Why is my Saeco Coffee Maker dispensing only water instead of coffee?
If your Saeco Coffee Maker is dispensing only water, it's possible that the pre-ground coffee selection button was pressed without adding coffee powder to the designated compartment. To fix this, add coffee to the compartment and start the cycle again.
How to fix Saeco IDEA RST when coffee comes out too quickly?
If the coffee is flowing too quickly from your Saeco Coffee Maker, the grind might be too coarse. Adjust the grind to a finer setting.
What to do if my Saeco Coffee Maker is not turning on?
If your Saeco Coffee Maker is not turning on, check the following: * Ensure the plug is properly connected. * Make sure the main switch (if present) is turned on. * Check the fuses in your electrical system. * Verify all electrical connections.
What to do if no water or steam comes out of my Saeco IDEA RST?
If no water or steam is coming out of your Saeco Coffee Maker, the hole in the steam/hot water tube might be blocked. Clean it with a thin needle.
What to do if my Saeco IDEA RST Coffee Maker is not hot enough?
If the coffee from your Saeco Coffee Maker isn't hot enough, it's likely that the cup wasn't preheated. Try preheating the cup on the cup warmer before brewing.
What to do if my Saeco IDEA RST displays 'Drawer full'?
If your Saeco Coffee Maker displays the message 'Drawer full', it means that the coffee grounds container is full. You should empty the container and reinsert it correctly.
How to fix Saeco IDEA RST when coffee comes out too slowly?
If the coffee is flowing too slowly from your Saeco Coffee Maker, the grind might be too fine. Adjust the grind to a coarser setting.
What to do if my Saeco IDEA RST Coffee Maker cappuccinatore is not dispensing milk?
If the cappuccinatore on your Saeco Coffee Maker is not dispensing milk, there could be a couple of reasons: * The milk might not be cold enough. * The milk container might be empty. Try moving the temperature adjustment lever down or refilling the milk container.
Why Saeco IDEA RST takes too long to heat up?
If your Saeco Coffee Maker is taking too long to heat up, it's likely that the machine's circuit is clogged with limescale. You should descale the machine.
What to do if my Saeco IDEA RST has little crema?
If the coffee from your Saeco Coffee Maker has little crema, the coffee blend may not be suitable, the coffee may not be freshly roasted, or the coffee powder may be ground too finely or too coarsely. Try changing the coffee blend or checking the grind if using pre-ground coffee.
General| Boiler Type | Stainless Steel |
|---|---|
| Hot Water Wand | Yes |
| Steam Wand | Yes |
| Weight | 10.5 kg |
| Pump Pressure | 15 bar |
| Boiler Material | Stainless Steel |
| Operation | Automatic |
To Next Page