Safety 1st Guide 65 - Page 9

1211
Attach 1st Harness Strap
Loops to Splitter Plate As
Shown
Sewn ends of the harness strap
loops must face towards you. Do
not twist harness strap or harness
adjustment strap.
Make sure the same harness
strap loops are fitted completely
on both sides of the splitter plate.
Harness strap loop ends must
go through the recline stand as
shown.
Harness adjustment strap must
lie under the harness strap as
shown.
From the Back of Seat,
Pull Harness Strap
Through Pad and Shell
Harness strap must be under the
headrest adjustment bar as shown.
Do not twist harness strap.
sewn
end
5
6
7
Place Child in Child
Restraint to Determine
Headrest Position
For Rear-Facing child fi t,
see page 8.
For Forward-Facing child
fi t, see page 9.
8
Adjust the Headrest
Squeeze the headrest
adjustment bar on the back of
the seat towards you.
Raise or lower the headrest to
position it behind your child’s
head.
Make sure the metal bar is
locked into position and above
the harness strap.
WARNINGS: The harness system must be installed
correctly. Do not use a child restraint with damaged
harness straps.
Recline Stand
Harness Adjustment
Strap
Check your child’s fit often.
If you cannot achieve a snug harness fit for your child,
see pages 15-17.
To learn how to check harness tightness, see pages 48-50.
Check the harness straps often for any wear or damage.