MF 5401
- 12 -
2 - Installation
Paper delivery stop
Adjust the paper delivery stop, depending on the format of
the document to be printed. Do not forget to raise the flap
to prevent the sheets from falling down.
Starting your device
Device connection
1 Connect the power cord to the device.
2 Make sure that the On/Off switch is on Off
(O position). Plug the power cord to outlet on the
wall.
3 Press the On/Off button to turn on the device
(I position).
4 After initialisation, WAITING FOR INIT CARD
appears on the screen. Insert the initialisation card
provided in the card reader as indicated on the
picture.
5 After an analysis phase, INIT. OK - REMOVE
CARD appears on the screen. Remove the
initialisation card from the drive.
6 The machine is set to English by default. To modify
this parameter, refer to the paragraph Setup the
display language, page 18.
Before plugging the power cord, it is
imperative to refer to the Security
directives, page 1.
As a precaution, in case of danger, the
power cord is used as a 230 V power
unit cut off. The outlet shall be located
close to the device and be of easy
access.
To Next Page
Loading...
Need help?
General
