SAILFISH 276 DC | BILGE PUMPS
All Sailfish Boats are furnished with Rule Bilge
Pumps, The Rule 2000 GPH (gallon per hour)
pump has a built in automatic float switch. This
is engaged when the water level rises in the
bilge and the float rises in the pump causing
the pump to turn on.
These pumps can be tested by turning them
upside down, the pump should turn on, once
turned back over it will run for a few more
seconds and then shut off. The pumps also
have a manual switch function on the main
switch panel.
These pumps are wired into your boat bypass-
ing the battery switch so that they have power
at all times, this allows the automatic feature to
work while you are away from the boat and the
batteries are turned off.
Sailfish boats 241CC and larger are equipped
with a forward bilge pump that is an electronic
sensor pump. These pumps have a state of the
art internal water sensor that detects water and
automatically activates the pump when there is
enough present to be pumped out.
These pumps can be tested by placing your
finger over the “Test Area” on the back of the
pump for 5 seconds, the pump will turn on to let
you know it is functioning correctly. All wiring
and switches to these pumps are the same as
the Rule 2000GPH pumps.
35
To Next Page
Loading...
