SAILFISH 276 DC | LIVEWELL OPERATION
Instructions
• Make sure the seacock below the baitwell
pump is in the open position (seacock is
accessed through the hatch under the tran-
som walk thru door).
• Turn on the livewell switch.
• Adjust the black aerator in the livewell to the
desired flow (if your model has a livewell in
the leaning post you can adjust the aerator to
pump water into the transom livewell or the
leaning post livewell or both)
• In order to fill the livewell, reach in the access
hatch below the livewell and close the red
handle ball valve.
• The livewell will fill up until it reaches the
Overflow built into the side of the livewell. This
allows the water to continually pump in and
drain out while maintaining the water level.
• To drain the livewell open the red handle ball
valve.
CLOSED
38
To Next Page
Loading...
