SAILFISH 276 DC | TYPE III MSD WASTE MANAGEMENT SYSTEM
System Features
Level Indication: When pressed, the level indicator will illuminate
for 1 minute. When the tank level reaches full, the indicator will
flash automatically to alert the user to empty the tank.
Sleep Mode: If the flashing LED is a disturbance, the unit can
be put into sleep mode. The unit will emerge from sleep if the
system is turned off or the tank level is increased. NOTE: the
unit is unable to be put into sleep mode if the tank is 7/8 full or
greater.
Empty Button: This button needs to be pressed and held for 3
seconds to activate the pump. This eliminates the possibility of
accidental operation.
Averaging: Two different level averaging methods have been
used – one when filling and one when emptying. This compen-
sates for the boat’s movement when the tank is filling, and still
allows an accurate reading when emptying.
Fail Safe Feature: If no fluid movement is sensed 20 seconds
after the pump is set to run, the pump will shut down and indi-
cate a fault check pump and plumbing for a blockage.
• Rugged Polyethylene holding tank
• Barbed fittings for all hose connections
• Heavy Duty Macerator
• Three run-dry and accidental activation
safety features
• Evacuation Pump
• Touch-pad waste management control panel
• Additional dock side evacuation pick up
PUMP FEATURES
Pump: Self-Priming Flexible Impeller with Stainless Steel Wearplate
Impeller: Jabsco Nitrile compound
Macerator: Stainless Steel Cutter reduces particle size to 1/8” (3mm) maximum
Seal: Lip Type
Ports:
Intec – 1-1/2: (38mm) Hose Barb and 1-1/2” N.P.T. (Male) Outer – 1”
(19mm) Hose Barb
Motor:
Permanent Magnet Type, Fully Enclosed with Stainless Steel Shaft
Includes Run-Dry Protection Device that shuts off pump. Powder coated
housing with sealed end bolts and bearings.
53
To Next Page
Loading...
