PAGE 2-1
RT2047 DSC - PART I
2 INSTALLATION
2.1 INSTALLATION HINTS
Before installation of a VHF RT2047 the following points must be observed:
WHAT FACILITIES WILL HAVE TO BE ENABLED ?
Selcall, private channels, US-mode, dual watch, scanning facilities, etc. The procedure for enabling these
facilities is described in the manual: INSTRUCTIONS FOR IDENTITY AND SERVICE PROGRAMMING
OF VHF RT2047. This manual will only be delivered to dealers and general agents where it will be at the
disposal of trained personal in their service facilities.
IN WHAT WAY TO INSTALL THE VHF RT2047 ?
In section 2.2. MOUNTING POSSIBILITIES there’s installation instructions for the VHF RT2047 as an
independent unit or in combination with other units in the Compact 2000 programme.
HANDSET.
Installation of handset, see section 2.4. HANDSET.
EXTERNAL LOUDSPEAKER.
An external loudspeaker 4-8 ohm (4 W) can be connected to the power connector J802 pin 1 and 6, see
section 2.7. POWER CONNECTOR + EXT. LOUDSPEAKER.
SPECIAL OPTIONS:
The signals ‘remote alarm for selcall’, ‘AF to information decoder’, ‘AUX I’ , ‘AUX II’ etc. are available,
see section 2.9. SPECIAL OPTIONS.
To Next Page
Loading...
Need help?
General
