35
SAIPA 141 / Maintaining and repairing manual Body and trimming
Then clean about ve centimeters wide of
the windshield glass support surface and
apply the sealer as 16 millimeters wide
from the glass edge. Wait until it dries.
Windshield glass installation:
Using a knife, smooth the sealer surface on
the body so that about one to two millime-
ters of the sealer thickness remain on the
body.
If the sealer is removed in some positions,
repair that position by using new sealer.
Note:
Cut the remaining sealer off at the instal-
lation position of front glass. If the thread
becomes too hot, there is possibility of rup-
turing. Therefore, to prevent from thread,
cool it down or wait for a while.
Assembling and disassembling of parts
To Next Page
Loading...
