36
SAIPA 141 / Maintaining and repairing manual Body and trimming
Install the weather strip around the wind-
shield glass edge as shown in the gure.
Then install the fasteners and make sure
that they don’t have any defect.
After drying the primer put the sealer in the
5 mm of the glass edge with 11mm thick-
ness and by the means of a special tool.
You can smooth the sealer if it is needed.
Clean the windshield glass edge by spe-
cial liquid and apply the primer. Wait until it
dries normally within 20 to 30 minutes.
Caution:
Be aware not to make the selected surface
dirty and do not touch the surface.
Assembling and disassembling of parts
To Next Page
Loading...
