37
SAIPA 141 / Maintaining and repairing manual Body and trimming
Make sure that there is no leakage from the
installation position, do the inverse of dis-
assembling steps.
Sealer drying time:
Temperature
Time for the
surface drying
Time for
drying
5°C About 1.5 h 12 h
20°C About 1 h 4 h
35°C About 10 min 2 h
After inserting sealer, remove the extra by
means of a cutter. Inspect the installation
position for sealing. If there is any leakage,
dry it completely and seal it again.
Now install the windshield glass at its prop-
er place.
Caution:
Keep the glasses down until complete dry-
ing of the sealer. It prevents room pressure
variation and inserting forces to the glass.
Assembling and disassembling of parts
To Next Page
Loading...
