Saitek X52 - PC Flight Simulator Connection

36
Settingwithusing2.4GreceiverForward: 
1. Set2.4GreceivertoPPMoutputmode(pleaseoperateaccording
tochapter“4.8SwitchbetweenPPMandPWMModeofthe
Receiver”); 
2. ConnecttheSBUSportofthereceiverwiththePPMinputport1of
the433Mrangeextender; 
3. ConnecttheCH12portofthereceiverwiththePPMinputport2
ofthe433Mrangeextender(iftherangeextenderonlyhaveone
PPMinputport,thenskipthisstep); 
4. In“OutputMode”ofWINDBOX,select“Built-in2.4G”. 
4.20 ConnectWINDBOXwithPCFlightSimulator
1. InstallsimulatorinthePC; 
2. Wiring.Inserttheaudioplugintothesoftdogofthesimulator; 
3. TheothersideofthesimulatorcableshouldconnectwiththePPM
outputportofWINDBOX; 
4. Openthe“OutputMode”menuoftheWINDBOX; 
5. Select“futabaPPM”foroption2. 

Ifthesimulatorcablewasmadebyusersthemselves,connectthetwo
wiresoftheaudioplugwiththePPMconnectorofWINDBOX. 