PDM20 Series
-42-
P0.39 Parameter lock function
0～1
0
After setting parameters, if you don’t want them to be modified by misoperation,
make P0.39= 1. At this time, parameters can only be monitored, but not be
modified. Only when P0.39 is modified to 0, can parameters be modified.
P0.40 Current fault type
0～29
Record fault type of the SPD. 0 means no fault. 1
～
29 refers to E001
～
E029. For
more details, please refer to fault inspection and troubleshooting chapter.
P1.34
Start/stop signal
choices
0～1
0
0：Start/stop by keyboard
1：Start/stop by terminals
P0.43
Frequency source
choices
0～8
8
0：Digital setting
1～7：Reserved
8：Water supply PID
Each SPD can choose different start/stop modes and frequency sources.
P1 group parameters have the same meaning as P0 group. Please refer to P0 group
for more details.
P1.06 Upper limit frequency
P1.07～60.0
Hz 50.00
P1.07 Lower limit frequency
0.00～P1.06
Hz 0.00
P1.08
Action choices when
running frequency is lower
than lower limit frequency
0：Run at lower limit frequency
1：Stop
2：Standby
2
To Next Page
Loading...
