SAJ PDS33-2S2R2 User Manual

PDS33 Series
- 41 -
Fault
code
Fault description
Possible causes
Remedy
Lower-rating controller
Replace with higher-rating
controller
Err05
Over-voltage during
acceleration
Abnormal input voltage
Check input power
Restart the motor when
instantaneous trip-off occurs
Avoid prompt restart when
trip-off
Err06
Over-voltage during
deceleration
Too-fast deceleration
Add proper braking units
Abnormal input voltage
Check input power supply or
wiring
Err07
Over-voltage at
constant running
speed
Abnormal input voltage
Adjust input voltage to
normal range
Err08
Overload of buffer
resistor
Abnormal input voltage
Adjust input voltage to
normal range
Err09
Under voltage of
DC bus
Too-low input voltage
Check input power supply or
wiring
Err10
Controller overload
Too fast acceleration
Increase acceleration time
Restart the motor when
instantaneous trip-off occurs
Avoid prompt restart when
trip-off
Too-low input voltage
Check input power supply or
wiring
Too-heavy load
Replace with higher-rating
controller
Err11
Motor overload
Incorrect setting of
FA.01&FA.02
Set the parameters correctly
Load too heavy or motor stuck
Reduce load，or check the
motor
Err12
Input phase loss
Abnormal input power source
Check input power source
and wiring

SAJ PDS33-2S2R2 Specifications

General

Brand	SAJ
Model	PDS33-2S2R2
Category	Control Unit
Language	English