SAJ R5-0.7K-S1 User Manual

R5 Series
- 48 -
Error Code
Explanation
51
Voltage Consistency Error Slave
54
Frequency Consistency Error Slave
57
GFCI Consistency Error Slave
61
Overvoltage Slave
62
Under Voltage Slave
67
Over Frequency Slave
68
Under Frequency Slave
73
Grid Lost Error Slave
76
PV1 Overvoltage Slave
77
PV2 Overvoltage Slave
81
Loss of Communication between Display Panel and Control Board
Master
86
DRM0 Error Master
Table 7.1 Error Code
General troubleshooting methods for inverter are as follows:
Fault Information
Troubleshooting
Relay Error
If this error occurs frequently, please contact your distributor
or call SAJ technical support.
Storer Error
If this error occurs frequently, please contact your distributor
or call SAJ technical support.
High Temperature
Error
Check whether the radiator is blocked, whether the inverter is
in too high or too low temperature. If the above mentioned are
in normal, please contact your distributor or call SAJ
technical support.
GFCI Device Error
If this error occurs frequently, please contact your distributor
or call SAJ technical support.
DCI Device Error
If this error occurs frequently, please contact your distributor
or call SAJ technical support.
Current Sensor Error
If this error occurs frequently, please contact your distributor
or call SAJ technical support.
AC Voltage Error
·Check the volt of the grid.
·Check the connection between the inverter and the grid.
·Check the settings of the on-grid standards of the inverter.

SAJ R5-0.7K-S1 Specifications

General

Brand	SAJ
Model	R5-0.7K-S1
Category	Inverter
Language	English