Sununo Plus Series
-33-
6.2.2 State
If the country has been set the LCD shows the machine type when the inverter is
started up, then it automatically displays the inverter operation status:Normal,Wait,
Fault, Update.
Data name Explanation
Normal
The inverter in normal (function) operation
Wait
The inverter in stand-by state
Fault
A fault occurs during operation
Update
The state of updating firmware
Turn on the AC switch, the LCD begins to count seconds backward, after this, the
inverter begins to connect the gird.
Figure 6.3 Count down Seconds
To Next Page
Loading...
Need help?
General
