Increase the volume. Press VOL+ on the
remote control or + on the unit.
Press on the remote control to ensure
the soundbar is not muted.
Press SOURCE button to select a different input
source.
To play/pause, press the button on the
remote control.
To skip a track, press the , buttons on
the remote control.
Troubleshooting
•
•
•
No power
•
•
•
Remote control does not work
•
•
•
•
•
No sound
•
•
•
•
•
•
To disconnect the Bluetooth function,
you can :
-
-
Tips:
•
•
•
•
•
•
If the connection is lost, follow the instructions
above to pair your device to the unit again.
-
-
1
2
3
-
-
EN
Switch to another source on the unit.
Disable the function from your Bluetooth device.
The Bluetooth device will be disconnected from
the unit after audio prompt.
Press and hold the /PAIR button on the
remote control.
Enter "0000" for the password if necessary.
If no other Bluetooth device pairs with this
unit within two minutes, the unit will
recover its previous connection.
The unit will also be disconnected when your
device is moved beyond the operational range.
If you want to reconnect your device to this
unit, place it within the operational range.
If the device is moved beyond the operational
range, when it is brought back, please check if
the device is still connected to the unit.
Listen to Music from Bluetooth Device
If the connected Bluetooth device supports
Advanced Audio Distribution Proe (A2DP),
you can listen to the music stored on the
device through the unit.
If the device also supports Audio Video Remote
Control Proe (AVRCP), you can use the unit's
remote control to play music stored on the
device.
Pair your device with the unit.
Play music via your device (if it supports A2DP).
Use supplied remote control to control play
(if it supports AVRCP).
To keep the warranty valid, never try to repair the
unit yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
Ensure that the AC power cord of the
unit is properly connected.
Ensure that there is power at the AC outlet.
Press standby button to turn the unit on.
Before you press any playback control button,
rst select the correct source.
Reduce the distance between the remote
control and the unit.
Insert the batteries with its polarities (+/-)
aligned as indicated.
Replace the batteries.
Aim the remote control directly to the sensor
in the front of the unit and there is no obstacle
between the remote control and the unit.
When using either of the Digital inputs, if there
is no audio:
- Try setting the TV output to PCM or
- Connect directly to your Blu-ray/other source,
some TVs do not pass through digital audio.
Your TV may be set to variable audio output.
Ensure that the audio output setting is set to
FIXED or STANDARD, not VARIABLE. Refer to
your TV's user manual for more detailed
information.
If using Bluetooth, ensure that the volume on
your source device is turned up and the device
is not muted.
| can't find the Bluetooth name of
this unit on my Bluetooth device for
Bluetooth pairing
Ensure the Bluetooth function is activated on
your Bluetooth device.
Ensure you have paired the unit with your
Bluetooth device.
This is a 15 mins power off function,
one ofthe ERPII stand ard requirement
for saving power
When the unit's external input signal level is
too low, the unit will be turned off automatically
in 15 minutes. Please increase the volume level
of your external device.
EN
-
14
To Next Page