29 VS20WRF and VS20BRF Installer Manual
Installation - System Setup
System setup checklist
1
The Universal Gateway/Zigbee coordinator
must be in pairing mode.
Before starting the pairing, make sure the light is flashing
on the universal gateway/coordinator by holding the
button for 5 seconds. For more information refer to the
universal gateway/coordinator instruction manual and
also follow the App instructions.
* The coordinator will be used only for the underfloor
systems that are not connected via the gateway.
2
The device that you intend to pair with must be ready
to accept pairing.
Please refer to pages 33-52 and the relevant device installation guides.
To Next Page
Loading...
