38 VS20WRF and VS20BRF Installer Manual
Installation - Pairing the Radiator Valve(s)
Radiator
Valve(s)
Checklist
1
The Zigbee coordinator or the Universal Gateway must be
in pairing mode. Hold the button for five seconds until it
flashed red.
2
Ensure that the radiator valves are in pairing mode (Refer to TRV manual).
A maximum of 6 radiator valves can be used with 1 thermostat. Pairing of
radiator valve. Please pair TRVs on a room by room basis.
3
If you are using the optional system receiver configured to RX1 for remote
boiler switching, ensure this has been powered up and the red flashing LED
has gone steady.
Set your system
parameters by following
the steps on pages 5-6.
5 sec
5 sec
Pairing without Internet connection using a CO10RF or a UG600/UGE600
PAIRING
WITH TRV
To Next Page
Loading...
