48 VS20WRF and VS20BRF Installer Manual
Installation - Testing Pairing with System Receiver RX2
Use to
increase
temperature to
30ºC and then
press
Green LED on
Green LED off
Use to
decrease
temperature to
10ºC and then
press
If you are using
the optional system
receiver configured
to RX1 please check
that the green light
goes on when the
temperature is
raised and off
when reduced.
If pairing for your system is complete,
please take the coordinator or the universal
gateway out of pair mode. Press for 5
seconds and light will stop flashing.
5 sec
5 sec
PAIRING
WITH RX2
To Next Page
Loading...
