4 Disassembly and Assembly
4-2 SAM4S SAP-630 SERIES
4-2 Disassembling the Case Lower Block
4-2-1 Ass’y Printer
1. Open the ASS'Y COVER PRINTER(B) and lift it off. (Page7-1)
2. Separate the GROUND(ⓙ and ⓛ) from the ASS'Y CASE LOWER(G). (Page7-6,Page7-11)
3. Remove the two screws(G-7) from the ASS'Y CASE LOWER(G). (Page7-11)
4. Separate the ASS'Y PRINTER from the ASS'Y CASE LOWER(G). (Page7-11)
4-2-2 Ass’y key Board
1. Separate the two FPC cables from the MOTHER BOARD(G-37).
And then lift off the ASS’Y KBD(E or F).(Page7-11)
4-2-3 Ass’y Dallas Key
1. Disconnect the Harness of the ASS’Y DALLAS KEY(G-5) from the MOTHER BOARD(G-37).(Page7-11)
2. Lift up the ASS'Y DALLAS KEY.
3. If don’t use it, only lift up COVER FRONT(G-6) from the ASS'Y CASE LOWER
(G).(Page7-15,Page7-11)
Note
There are three types in DALLAS KEY; ADDIMAT KEY, DALLAS KEY or ADDIMAT KEY
4-2-4 Ass’y MOTHER BOARD
1. Separate the six harnesses(ⓒ,ⓘ,ⓜ,ⓝ,ⓡ,ⓢ) and remove the six screws(G-38:5pcs,G-42:1pcs).
Separate the MOTHER BOARD(G-37).(page7-11)
4. Remove the one screw(G-43) and separate the PLATE SHIELD(G-35) from the ASS’Y LOWER(G). (page7-11)
4-2-5 Ass’y USB BOARD
1. Remove the one screw(G-12) and separate the harnesses(n) from the MOTHER BOARD(G-37).(Page7-11)
Lift up the USB BOARD(G-11).(Page7-11).2.
2. Remove the one screw(G-40) and separate the Wifi/Bluetooth module from the MOTHER BOARD(G-37).
3.
To Next Page
Loading...
