Precaution Statements
Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards
such as electrical shock.
6. Observe the original lead dress, especially near
1-1 Safety Precautions the following areas : sharp edges, and
1. Be sure that all built-in protective devices are especially the AC and high voltage supplies. replaced.
Restore any missing protective Always inspect for pinched, out-of-place, or
shields. frayed wiring. Do not change the spacing
2. When reinstalling the chassis and its between components and the printed circuit assemblies, be sure to
restore all protective board. Check the AC power cord for damage. devices, including nonmetallic control
knobs Make sure that leads and components do not and compartment covers. touch
thermally hot parts.
3. Make sure there are no cabinet openings 7. Product Safety Notice:
through which people - particularly children - Some electrical and mechanical parts have might insert
fingers and contact dangerous special safety-related characteristics which voltages. Such openings
include might not be obvious from visual inspection. excessively wide cabinet ventilation slots and
These safety features and the protection they improperly fitted covers and drawers. give might be
lost if the replacement
4. Design Alteration Warning: component differs from the original - even if Never alter or add to the
mechanical or the replacement is rated for higher voltage, electrical design of the SAM4POS.
wattage, etc.
Unauthorized alterations might create a safety Components that are critical for safety are hazard. Also,
any design changes or additions indicated in the circuit diagram by shading, will void the
manufacturer’s warranty. ( ) or ( ). Use replacement components
5. Components, parts and wiring that appear to that have the same ratings, especially for have overheated
or that are otherwise damaged flame resistance and dielectric strength should be replaced with parts that
meet the specifications. A replacement part that does original specifications. Always determine the
not have the same safety characteristics as the cause of damage or over- heating, and correct
original might create shock, fire or other any potential hazards. hazards.
CAUTION ATTENTION
Danger of explosion if battery is incorrectly ll y a danger d’explosion s’il y a remplacement replaced.
incorrect de la batterie.
Replace only with the same or equivalent type Remplacer uniquement avec une batterie du même
recommend by the manufacturer. type ou d’un type équivalent recommandé par le
Dispose used batteries according to the constructeur.
manufacturer’s instructions. Mettre au rebut les batteries usagées conformément aux instructions du
fabricant.
To Next Page
Loading...
Need help?
General
