Performing EFT Operations
When performing EFT Operations, the EFT Operation communication between the ECR and the Tran
device is displayed on the SAM4POS. When the specified operation is completed, the register will
print the results of the requested operation at the register’s receipt printer. You can also print out the
EFT Operation communication to the register receipt if desired.
Initialize EFT
Select Initialize EFT to verify communications, software versions and installed networks.
1. From the main PROGRAM MODE menu screen, select DEVICE, then touch EFT
OPERATION.
2. Select Datatran_Operation from the selections.
3. Select INITIALIZE EFT. The register will display “Information Working” 4. The EFT
OPERATION dialog is displayed:
5. You can PRINT the response if desired; then press CLOSE.
Sample Initialize EFT chit:
To Next Page
Loading...
