SamplexPower EVO-RC - Page 41

SAMLEX AMERICA INC. | 41
APPENDIX A
i
INFO
When using Charging Prole options (i) “1=3Stage Type 1” or (ii) “3=2Stage Type1, a nearly fully charged
battery may be overcharged / boil if the programmed duration of “ABSORP TIME” is excessively long. Care
should be taken to determine the time the battery is required to remain in Absorption Stage (“ABSORP TIME”)
based on the application and then, set programming parameter “ABSORP TIME” accordingly
Programmable range is 0 – 600 min. Default value is 60 min
4.4.2.19.1 Programming Steps for Parameter “ABSORP TIME”
Enter Key Enter Key Up Key x 18 times Enter Key
A N Y O P E R A T I N G
M O D E S C R E E N
ð
S E L E C T G R O U P
C H A R G E C U R V E
ð
B U L K C U R R E N T
4 0 A
ð
A B S O R P T I M E
6 0 m i n
ð
K E Y I N P A S S WO R D
0 0 0 0
Password 8052
See Section 4.3.1
ð
A B S O R P T I M E
0 6 0 m i n
4.4.2.20 ABSORP EXIT AMPS (Table 4.1, Parameter Setup Screen No. 20)
Parameter “ABSORP EXIT AMPS” is used to set the value of the charging current at which the charger will exit Absorption
Stage and transition to Float Stage when the following option for programming parameter “Charging Prole” (See
Section 4.4.2.21) is selected”
• 2=3 Stage Type 2
Programmable range is 0 – 20A. Default value is 4A
4.4.2.20.1 Programming Steps for Parameter “ABSORP EXIT AMPS”
Enter Key Enter Key Up Key x 19 times Enter Key
A N Y O P E R A T I N G
M O D E S C R E E N
ð
S E L E C T G R O U P
C H A R G E C U R V E
ð
B U L K C U R R E N T
4 0 A
ð
A B S O R P E X I T A M P S
4 A
ð
K E Y I N P A S S WO R D
0 0 0 0
Password 8052
See Section 4.3.1
ð
A B S O R P E X I T A M P S
0 4 A
4.4.2.21 CHARGING PROFILE (Table 4.1, Parameter Setup Screen No. 21)
Parameter “CHARGING PROFILE” provides 6 options for Charging Proles that are designed to cover various charging
requirements for Lead Acid, Nickel-Zinc (Ni-Zn) and Lithium Ion Batteries.
i
INFO
7th Charging Prole i.e. 4-Stage Adaptive Charging Prole for Equalization is also available and can be activated
at any time during charging taking place under 1 of the 6 Charging Prole options given at Section 4.4.2.21
above. Procedure to activate 4-Stage Adaptive Charging Prole for Equalization is described under programming
parameter “EQUALIZE- 4 STAGES” at Section 4.4.2.12
The 6 options under parameter "CHARGING PROFILE" are as follows:
• 0 = 3 Stage Adaptive (Default)
• 1 = 3 Stage Type 1
• 2 = 3 Stage Type 2
• 3 = 2 Stage Type 1
• 4 = 2 Stage Type 2
• 5 = 2 Stage Type 3
SECTION 4 | Parameter Setup