Need help?Do you have a question about the Samson 4060/4120 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| Input Impedance | 20k Ohms Balanced, 10k Ohms Unbalanced |
| Power (8 Ohms) | 400W per channel |
| Frequency Response | 20Hz-20kHz |
| Signal to Noise Ratio | >100dB |
| Outputs | Binding Post |
Controls the power to the Servo Quad Amplifier, turning it on or off.
Indicates when the Servo Quad Amplifier is powered on.
Adjusts the input level for each of the four amplifier channels.
Monitors the power output level for each channel, indicating signal strength and clipping.
Indicates status of protection circuitry, muting speakers during power-up/down or faults.
Connects the supplied 3-pin 'IEC' power plug.
Location for the fuse, with specific ratings for different voltage operations.
Connects each amplifier channel to loudspeakers using binding posts.
Electronically balanced 1/4" TRS jacks for incoming signal.
Unbalanced RCA-type jacks for incoming signal.
Enables bridge stereo mode for increased power output.
To Next Page
