Samson 43 Series - 1 General Safety Instructions

4 EB 2172 EN
General safety instructions
1 General safety instructions
– The device must be mounted, started up or serviced by fully trained and
qualied personnel only; the accepted industry codes and practices are to
be observed. Make sure employees or third persons are not exposed to any
danger.
– All safety instructions and warnings given in these mounting and operating
instructions, particularly those concerning installation, start-up and mainte-
nance, must be strictly observed.
– According to these mounting and operating instructions, trained personnel
refers to individuals who are able to judge the work they are assigned to
and recognize possible dangers due to their specialized training, their
knowledge and experience as well as their knowledge of the applicable
standards.
– The devices comply with the requirements of the European Pressure Equip-
ment Directive 2014/68/EU. Devices with a CE marking have a declaration
of conformity, which includes information about the applied conformity as-
sessment procedure. This declaration of conformity can be provided on re-
quest.
– To ensure appropriate use, only use the device in applications where the op-
erating pressure and temperatures do not exceed the specications used for
sizing the device at the ordering stage.
– The manufacturer does not assume any responsibility for damage caused by
external forces or any other external factors.
– Any hazards that could be caused in the temperature regulator by the pro-
cess medium, operating pressure or by moving parts are to be prevented by
taking appropriate precautions.
– Proper transport, storage, installation, operation and maintenance are as-
sumed.
Testing according to DINEN
The Type43-5, Type43-6 and Type43-7 Temperature Regulators are
tested by the German Technical Inspectorate (TÜV) according to
DINEN14597. The register number is available on request.