Samson 3372 - User Manual

Other manuals for Samson 3372

User Manual8 pages

Questions and Answers

A
Adam GuerreroJul 27, 2025
What to do if the Samson 3372 actuator stem does not move on demand?
- T
  Tammy AyalaJul 27, 2025
  If the Samson Controller actuator stem isn't moving, there might be a few reasons. First, the actuator could be blocked. You should check its attachment and unblock it. Be careful, as a blocked actuator can suddenly move uncontrollably, potentially causing injury. Disconnect the pneumatic air supply and control signal before attempting to unblock it, and release any stored energy, like spring compression, beforehand. Another possibility is insufficient signal pressure, so check the signal pressure and the signal pressure line for leaks. Also, ensure the signal pressure is connected to the correct diaphragm chamber. If none of these solutions work, the diaphragm in the actuator may be defective.
J
Joseph AndersonAug 4, 2025
Why is the Samson 3372 Controller actuator stem not stroking through its complete travel range?
- A
  Angela JacobsAug 4, 2025
  If the Samson Controller actuator stem isn't stroking through its complete travel range, start by checking the signal pressure and the signal pressure line for any leaks, as insufficient signal pressure could be the cause. Also, incorrect settings of valve accessories might be the problem. Inspect the actuator without valve accessories and verify the settings of the valve accessories.
S
Samantha GardnerAug 11, 2025
What to do if the actuator stem does not move on demand on my Samson 3372?
- M
  Michael CastilloAug 11, 2025
  If the actuator stem on your Samson Controller isn't moving when it should, there could be several reasons. First, the actuator might be blocked. Inspect the attachment and carefully unblock it. Be cautious, as a blocked actuator can suddenly move uncontrollably, potentially causing injury. Disconnect the pneumatic air supply and control signal before attempting to unblock it, and release any stored energy. Another possibility is insufficient signal pressure. Check the signal pressure and look for any leaks in the signal pressure line. Also, ensure the signal pressure is connected to the correct diaphragm chamber. Finally, the diaphragm in the actuator could be defective.
J
Jamie HernandezAug 18, 2025
Why actuator stem does not stroke through its complete travel range on Samson 3372 Controller?
- S
  stevenhopkinsAug 19, 2025
  If the actuator stem on your Samson Controller isn't stroking through its complete travel range, it might be due to a few reasons. Insufficient signal pressure could be the cause, so check the signal pressure and look for any leaks in the signal pressure line. Another reason might be incorrect settings of valve accessories. Try checking the actuator without valve accessories first, and then check the settings of the valve accessories.