What to do if the Samson Control Unit valve leaks to the atmosphere?
If the Samson Control Unit valve leaks to the atmosphere, it could be due to a defective plug stem seal or a loose flanged joint with a worn-out gasket. You should check the flanged joint. For a defective plug stem seal, it is recommended to contact our after-sales service.
Why does the Samson Control Unit actuator and plug stem not move on demand?
If the actuator and plug stem of your Samson Control Unit do not move on demand, it could be because the actuator is blocked or there's no or incorrect supply voltage connected. Check the attachment and remove any blockage. Also, check the supply voltage and connections.
What to do if there is increased flow through closed Samson Control Unit valve?
If you observe increased flow through a closed Samson Control Unit valve, it might be caused by dirt or foreign particles between the seat and plug, or the valve trim could be worn out. To resolve this, shut off the section of the pipeline and flush the valve. If the valve trim is worn, contact our after-sales service.
Why actuator and plug stem does not stroke through the full range in Samson Control Unit?
If the actuator and plug stem of your Samson Control Unit don't stroke through the full range, the cause may be no or incorrect supply voltage connected. Ensure that you check the supply voltage and connections.
What to do if there is an input signal failure in my Samson 3374-11 Controller?
If you are experiencing an input signal failure with your Samson Controller, the suggested solution is to check the signal source and wiring.
What to do if my Samson Controller shows a sensor failure?
If your Samson Controller indicates a sensor failure, you should check the signal source and wiring.
What should I do if my Samson 3374-11 shows plausibility error?
If your Samson Controller is showing a plausibility error, the suggested solution is to correct the configuration.
What should I check if there is a bus failure on my Samson 3374-11?
In case of a bus failure on your Samson Controller, you should check the Modbus master and connection.
What to do if my Samson 3374-11 Controller is blocked?
If your Samson Controller is experiencing a blockage, you should unblock the stem and valve.
What to do if my Samson Controller displays 'EEPROM error: no configuration'?
If your Samson Controller displays the error message 'EEPROM error: no configuration', you should perform the configuration again.
General overview of the Type 3374 Electric Actuator.
Safety warnings about severe personal injury risks.
Safety warnings about personal injury risks.
Details regarding the actuator's nameplate information.
Procedures for manually operating the actuator stem.
Identification of actuator components and controls.
Comprehensive technical specifications and performance data.
Choosing between automatic and manual operating modes.
Step-by-step guide for actuator initialization and setup.
Selection and configuration of actuator applications.
Procedure for performing zero calibration of the actuator.
Steps for initializing the actuator.
Comprehensive list and explanation of actuator error messages.
Guidance for diagnosing and resolving common actuator malfunctions.
Step-by-step instructions for detaching the actuator from the valve.
Procedures for mounting the actuator onto the valve.
Instructions for making electrical connections to the actuator.
Procedures for activating and changing configuration parameters.
Configuration of input signal source and range.
Quick configuration of key parameters.
General| Model | 3374-11 |
|---|---|
| Velocity Sensitivity | Yes |
| Aftertouch | No |
| Pitch Bend | Yes |
| Modulation Wheel | Yes |
| Type | MIDI Controller |
To Next Page
