Need help?Do you have a question about the Samson 3725 and is the answer not in the manual?
General| Channels | 16 |
|---|---|
| Keys | 25 |
| Velocity Sensitivity | Yes |
| Aftertouch | No |
| Pitch Bend | Yes |
| MIDI I/O | USB |
Details hazards that could result in death or serious injury.
Details hazards that could result in personal injury.
Details potential risks of property damage.
Describes the information provided on the device's nameplate.
Explains the structure and meaning of the article code.
Describes various methods for attaching the positioner to different actuators.
Lists available accessories and required mounting parts.
Correlates actuator sizes with travel ranges and positioner settings.
Provides detailed technical specifications and operating parameters.
Illustrates the physical dimensions of the positioner with drawings.
Instructions for safely unpacking the positioner and its components.
Guidelines for safe transportation and handling of the device.
Recommendations for storing the positioner properly.
How to set the lever and pin for proper actuator adaptation.
Detailed instructions for mounting directly onto specific actuator types.
Procedures for mounting using a NAMUR bracket.
Instructions for attaching to SAMSON Type 3372 actuators.
Procedures for mounting the positioner to rotary actuators.
Guidance on making correct pneumatic connections to the device.
Steps and requirements for connecting the air supply.
Instructions for safely connecting the electrical power and signal.
Explains the function of capacitive keys, display, and volume restriction.
How to adjust the display reading direction.
Steps to unlock configuration settings for parameter changes.
Guide for setting the volume restriction for actuator adaptation.
How to set the air action (ATO or ATC).
How to set the direction of action (increasing/decreasing).
How to activate signal pressure limitation for valve protection.
Overview of parameter codes and their default settings.
Process for adapting the positioner to actuator conditions.
Steps to recalibrate the positioner's zero point.
How to operate the positioner using manual mode.
How to reset the positioner to default settings.
Instructions for preparing the unit for return to SAMSON.
Procedure for resetting specific error codes.
List of error codes, their causes, and recommended actions.
Actions to take in case of critical failures or emergencies.
Steps to safely take the positioner out of operation.
Instructions for physically removing the positioner from the valve.
Guidance on proper disposal of the equipment and its components.
Information on contacting SAMSON for support and service.
Detailed list of parameter codes and their functions.
To Next Page
