Need help?Do you have a question about the Samson 3730-1 and is the answer not in the manual?
General| Supply air pressure | 1.4 to 7 bar (20 to 100 psi) |
|---|---|
| Housing material | Aluminum |
| Protection class | IP 65 |
| Output Signal | Pneumatic |
| Pressure Range | Up to 7 bar (100 psi) |
| Port Size | G1/4 or 1/4" NPT |
| Material | Aluminum |
| Accuracy | ±1% of span |
Details potential risks and necessary precautions for severe personal injuries.
Provides information on potential risks and preventive measures for personal injury.
Outlines risks and precautions to prevent damage to the positioner or related equipment.
Specifies requirements and considerations for using the device in explosive atmospheres.
Describes the details and labels found on the device's nameplate for identification.
Details the structure and meaning of the product's article code.
Lists revisions and compatibility information for different firmware versions.
Describes various ways the positioner can be attached to different actuators.
Lists available accessories for the positioner and their order numbers.
Provides detailed technical specifications, including performance and environmental limits.
Illustrates the physical dimensions of the positioner for installation planning.
Guidance on safely removing the positioner from its packaging.
Instructions for protecting the device during transportation.
Recommendations for proper storage to prevent damage and maintain integrity.
Specifies correct orientation and placement for mounting the positioner.
Details the process for directly mounting the positioner onto specific actuators.
Instructions for mounting the positioner using the NAMUR standard.
Provides instructions for making electrical connections safely and correctly.
Steps to adjust air output capacity based on actuator size.
Guides on setting the valve's fail-safe state (ATO/ATC).
Procedure for adapting the positioner to actuator conditions.
Instructions for recalibrating the zero point for accuracy.
Steps to follow when returning the positioner for repair.
Guidance on actions to take during valve or actuator failures.
Procedure for safely shutting down and preparing the positioner.
Instructions for environmentally responsible disposal of the unit.
Information on how to contact SAMSON for support and service.
Reference for all parameter codes, their values, and descriptions.
List of error codes, their causes, and recommended corrective actions.
To Next Page
