Samson 3730-1 - Servicing Information; Preparation for Return Shipment

78 EB 8384-1 EN
Servicing
8 Servicing
The positioner was checked by SAMSON
before it left the factory.
− The product warranty becomes void if
service or repair work not described in
these instructions is performed without
prior agreement by SAMSON's After-sales
Service department.
− Only use original spare parts by
SAMSON, which comply with the original
specications.
The positioner does not require any mainte-
nance.
Housing cover
Occasionally, the window in the cover may
need to be cleaned.
Incorrect cleaning will damage the window.
The window is made of Makrolon
®
(new de-
sign) and will be damaged when cleaned
with abrasive cleaning agents or agents con-
taining solvents.
− Do not rub the window dry.
− Do not use any cleaning agents containing
chlorine or alcohol or abrasive cleaning
agents.
− Use a non-abrasive, soft cloth for cleaning.
Filters
Therearelterswitha100µmmeshsizein
the pneumatic connections for supply and
output which can be removed and cleaned,
if required.
Supply air pressure reducing stations
The maintenance instructions of any up-
stream supply air pressure reducing stations
must be observed.
8.1 Preparation for return ship-
ment
Defective positioners can be returned to
SAMSON for repair.
Proceed as follows to return devices to
SAMSON:
1. Put the control valve out of operation.
See associated valve documentation.
2. Removethepositioner(seesection10).
3. Send the positioner to your nearest
SAMSON subsidiary. SAMSON
subsidiaries are listed on our website at
uwww.samson.de>Contact.
Note
NOTICE
!