Samson 3730-1 Installation Instructions

























EYVAZ
A : Installation and Maintenance
B: Error code

code

Error

Description
E10

Not assigned



E11



Hardware
RC

Samson
Defective ceramic oscillator, positioner continues to
run with an internal RC oscillator ,but it should be
replaced as soon as possible
Recommended action : Return positioner to
SAMSON AG for repair.
E12


No factory
calibration

Samson
No factory calibration performed, memory defective.
Recommended action : Return positioner to
SAMSON AG for repair.

E13


Memory fault

Samson
Fault in the memory management
Recommended action : Return positioner to
SAMSON AG for repair.
E14

Checksum

Checksum error
data memory

Samson
Date memory defective
Recommended action : Return positioner to
SAMSON AG for repair.
E15
Checksum


Checksum error
calibration data

Samson
Date memory defective
Recommended action : Return positioner to
SAMSON AG for repair.








Installation Instructions


I to P Positioner

WWW.EYVAZTECHNIC.COM
INFO@EYVAZTECHNIC.COM & EYVAZTECHNIC@YAHOO.COM
Type 3730-1-Samson

    Samson
      

 Samson 
Attention : information of this
manual is just translated from
Samson manual and there is
limitation in it ,for more
information , please refer to
Samson manual or website .

Samson 3730-1 Specifications

General

Supply air pressure	1.4 to 7 bar (20 to 100 psi)
Housing material	Aluminum
Protection class	IP 65
Output Signal	Pneumatic
Pressure Range	Up to 7 bar (100 psi)
Port Size	G1/4 or 1/4" NPT
Material	Aluminum
Accuracy	±1% of span