Samson 3730-1 - Firmware Version History

EB 8384-1 EN 13
Safety instructions and measures
2.3 Firmware versions
TheseMountingandOperatingInstructionsarevalidforrmwareversions2.20to2.29.The
revisionslistedinthetableapplytormwareversion2.02andhigher.
Table1: Firmware revisions
2.02 (old) 2.10 (new)
NewResetfunctioninCodeP0.Seesection11.3.
NewManualmodefunctioninCodeP14.Seesection11.3.
2.10 (old) 2.11 (new)
Internal revisions
2.11 (old) 2.12 (new)
Internal revisions
2.12 (old) 2.20 (new)
• Parameter change: Nominal range (P4)
• New assignment of parameter codes: Manual mode (P17) and Reset (P18)
• New parameter codes: Firmware version (P20) and Control mode (to include
integral-actioncomponent,P21).Seecodelistonpage82onwards.
• NewassignmentoferrorcodesE8toE15.Seeerrorcodesonpage85on-
wards.
2.20 (old) 2.21 (new)
Optimized detection of zero and initialization routine
2.21 (old) 2.22 (new)
• P12 (limit A1) and P13 (limit A2) parameters: adjustment ranges extended to
0-100%(samebehaviorasinrmware2.20).Seesection11.3.
• P4 parameter (nominal range): adjustment ranges extended. See code list in
section11.3.