Samson 3374-11 - 9.13 Fast configuration level

62 EB 8331-4 EN
Congurationlevel
9.13 Fastcongurationlevel
Code 8 opens the fast conguration level, which allows the selection of several parameter
congurations.
Code Description Display Adjustment range
8 Fast conguration FCO In, Out, dir (see table below)
The settings for the following areas can be selected:
− Input signal (Code In)
− Position feedback signal (Code Out)
− Operating direction (Code dir)
Code Description Display
In
Input signal 0 to 20mA 0 – 20
Input signal 4 to 20mA 4 – 20
Input signal 0 to 10V 0 – 10
Input signal 2 to 10V 2 – 10
Out
Position feedback signal 0 to 20mA 0 – 20
Position feedback signal 4 to 20mA 4 – 20
Position feedback signal 0 to 10V 0 – 10
Position feedback signal 2 to 10V 2 – 10
dir
Operating direction increasing/increasing >>
Operating direction increasing/decreasing <>
Only one setting can be selected for each range. Selected settings are marked on the display
by dashes (see next page).
Note