Samson 3374-11 - 11 Service Level; Activating and Setting Parameters

EB 8331-4 EN 67
Service level
11 Service level
The service level contains detailed information on the actuator and its operating state. Addi-
tionally, various test functions can be performed in this level. Codes in the diagnostic level
have a 'd' prex to identify them.
All the parameters of the service level are listed in section17.2.5 on page89.
11.1 Activating and setting parameters
Activate the service level
1. Turn (when the start screen appears) to select Code 20.
2. Press to activate the service level.
(display: d01).
Exampleshown:Starttransittimemeasurement
1. Turn
to activate Code d61.
2. Press . The reading blinks on the display.
3. Press
again to start the transit time measurement.
Î The transit time measurement can be canceled at all times by
selecting ESC.
Exiting the service level
1. Turn
to select the code d00 (ESC).
2. Press to exit the service level.