Samson 3374-11 - 7 Operation; Display

36 EB 8331-4 EN
Operation
7 Operation
7.1 Display
After switching on the power supply, the current rmware is displayed for two seconds. Af-
terwards, the start screen appears.
%
On starting up the actuator for the rst time, the start screen and the error reading E00 (no
initialization performed) appear in alternating sequence.
Fig.13:Start screen after starting up the actuator for the rst time
Start screen
The start screen (Fig.14) depends on the selected application (see section8.4 on
page45). On starting up the actuator for the rst time and after loading default settings,
the positioner application (POSI) is automatically selected.
%
Start screen with positioner
application(POSI/POSF)
Displayed reading: travel
%
Start screen with PID con-
troller (PID) application
Displayed reading: process
variable
Start screen with two-step
mode application (2STP)
Displayed reading: state
Start screen with three-
step mode application
(3STP)
Displayed reading: state
Fig.14:Start screen depending on application