Samson 3374-11 - Service Level

EB 8331-4 EN 89
Decommissioning and disassembly
Code Parameters (read only) Reading/unit Section
Diagnostics
i61 Travel cycles From 10000 onwards, reading in K
i62 Temperature inside actuator °C
i63 Lowest temperature inside actuator °C
i64 Highest temperature inside actuator [°C] °C
i00 Exit information level
17.2.5 Service level
Code Parameters Display/selection
(select ESC to cancel)
Section
Information – Actuator
d01 Firmware version
u Read only 15
d02 Revision number
u Read only 15
Errors – Status
d10 Error during operation
u Read only
YES
NO
15
d11 Priority position triggered
Errors – Fatal errors
d20 No initialization performed
u Read only
YES
NO
15
d21 Input signal failure
d22 Blockage
d23 Both limit contacts active
d24 Canceled while retracting stem
d25 Canceled while extending stem
d26 Motor or potentiometer not turning
d26 Sensor failure
Error – EEPROM error
d31 EEPROM error: Basic setting
u Read only
E RD (read error)
E WR (write error)
15
d32 EEPROM error: Conguration
d35 EEPROM error: Calibration
d36 EEPROM error: Potentiometer calibration
d41 EEPROM error: Serial number