Fig.1: Type3372 Actuator with integrated
i/p converter mounted onto
Type3321 Valve
Fig.2: Type3372 Actuator · 120cm²
actuator area · With
Type3725 Positioner (direct
attachment)
Fig.3: Type3372 Actuator · 350cm²
actuator area · With
Type3725 Positioner (direct
attachment)
Fig.4: Type3372 Actuator (120cm²) with additional
Type4744‑2 Limit Switch
The Type3372 Electropneumatic Actuator is available in the
following versions:
• Version with integrated i/p converter, 120cm² actuator
area and 15mm rated travel (Fig.1)
• Version withType3725Positioner(directattachment),
120cm²actuator area and 15mm rated travel (Fig.2)
• Version withType3725Positioner(directattachment),
350cm²actuator area and 15 or 30mm rated travel
(Fig.3)
The actuators are suitable for attachment to Series V2001
Valves (e.g. Type3321, Type3323, Type3531, Type3535)
as well as Type3214 and Type3260 Valves. The actuators
mainly consist of two diaphragm cases, a rolling diaphragm
and internal springs. The Type3372 Electropneumatic Actua-
tor is controlled by a 4 to 20mA signal. For throttling service,
an i/p converter is integrated into the actuator or a Type3725
Positioner is mounted to the rod-type yoke using a support ele-
ment.
Furtherversions
– Permissibleoperatingtemperaturesfrom–35to+90°C
Only when a positioner is mounted
– Mechanicallyadjustablelimitstop · Only when a posi-
tioner is mounted and for 120cm² actuators
– Handwheel · Only when a positioner is mounted and for
120cm² actuators
– Explosionprotection for a mounted Type3725 Positioner
II2GExiaIICT4 according to ATEX, intrinsically safe
ExiaIICT4 according to CSAGroup, 1ExiaIICT4GbX
according to GOST
Accessories
– Type4744‑2LimitSwitch (Fig.4) · With explosion protec-
tion II2GExdbIICT6-T5 and degree of protection IP66
A clamping plate can be used to mount it · See Data Sheet
uT8367
Type3372ElectropneumaticActuator
Application
Electropneumatic linear actuators for attachment to Type3214
and Type3260 Valves as well as SeriesV2001 Valves
Ratedtravel 15and30mm
Actuator area 120and350cm²