Samson 4765 - Preparation for Use; Unpacking and Transporting; Storage Guidelines

EB 8359-1 EN 13
Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any transportation
damage.
4.1 Unpacking
Risk of positioner damage due to foreign
particles entering it.
Do not remove the packaging and protective
lm/protective caps until immediately before
mounting and start-up.
1. Remove the packaging from the position-
er.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting
− Protect the positioner against external in-
uences (e.g. impact).
− Protect the positioner against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see technical data in section3.2).
4.3 Storage
Risk of positioner damage due to improper
storage.
− Observe the storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different
storage conditions or long storage periods.
Storage instructions
− Protect the positioner against external in-
uences (e.g. impact, shocks, vibration).
− Do not damage the corrosion protection
(coating).
− Protect the positioner against moisture
and dirt. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section3.2).
− Store the positioner with the cover
closed.
− Seal the pneumatic connections.
NOTICE
!
NOTICE
!