14
Stacking and Tilting the C que 8
Installing the Tilting Feet
You can install the tilting rubber feet included
with your C que 8 so that you can set the unit
at a comfortable operating angle on a worksta-
tion or desktop. Follow the simple instructions
below to install the tilting feet.
• Remove the bottom screw from right
front bumper.
• Identify the right tilting foot by the locat-
ing “R” marking on the inside top.
• Position the angled foot under the right
bumper as shown in the drawing.
• Use the included 3 x 16mm screw to
attach the foot.
• Repeat the steps above for the front left
bumper.
Stacking the C que 8
You can stack one C cue 8, or
any other Samson C Class
units, on top of each other by
simply lining up the bumpers.
Important Note: When stack-
ing the C que 8, be sure that
only the bottom unit has the
tilting feet installed.
• Remove the bottom screw from right front bumper.
• Identify the right tilting foot by the locating “R” marking on the inside top.
• Position the angled foot under the right bumper as shown in the drawing.
To Next Page
Loading...
