Samson Graphite 49 - Setup Mode Configuration; Adjusting Controller and Parameter Settings

To Next Page

To Previous Page

Graphite 49 · USB/MIDI Keyboard Controller

Setup Mode

Setup mode enables you to make adjustments to how the Graphite 49 will operate. Pressing the

SETUP button will enter Setup Mode, the keyboard will stop transmitting MIDI data, and the rst

17 keys will function as numerical pads.

Controllers

To adjust a controller, press a button, move a slider

or encoder, or press the pedal, and its name and

parameter values will appear on the display.

Press the PAGE ◀ / ▶ buttons to cycle through the

available parameters. The parameter name will be

displayed and the value will ash. Use the DATA

+/– buttons or numerical keys to set the appropri-

ate value.

Note: When the value Ch is set to “-“, the controller

follows the keyboard channel in Zone 1. You can use

the DATA button to select “-“, or press the 0 key on the

keyboard to select “-“.

Press the ENTER button or the ENTER key on the

keyboard to conrm a selection. You can conrm

the selection after each parameter, or after you

nish editing all parameters for a controller. The

new values will be saved and updated on the

display.

Note: The slider and encoder settings are saved into the current activated bank. Press the BANK ◀ / ▶

to change the bank where the settings will be saved.

If you select another controller, or press the SETUP or MAIN buttons before saving your changes,

your changes will be lost. Simultaneously pressing the DATA + and DATA – buttons will restore the

controller to its original setting.

The setting of sliders, encoders and transport buttons cannot be changed in the Remote Control

Preset. The components assigned to the function buttons vary according to the software title you

are using.