Meteor Mic USB Studio Condenser Microphone
Follow this simple quick start for a typical set-up to start recording.
1. Unfold the legs of the Meteor Mic, and position the microphone
on your desktop. The legs can be adjusted to set the angle of the
microphone.
2. Connect your headphones to the Headphone output located on the
rear of the Meteor Mic.
3. Plug the mini-B (small) end of the included USB cable into the
USB socket on the rear of the Meteor Mic and plug the other end
of the USB cable into an available USB port on your computer.
4. Set the computer’s output level is set to maximum for full volume
in the Meteor Mic headphone monitor.
5. Launch your recording software, turn the microphone’s Volume
knob down, and select the Meteor Mic for the input and output.
6. Set up a mono record track in your software for the vocal track.
7. Set the level of the microphone following the instructions in “Connecting
to a Computer”. If you see the Power/Peak LED illuminate red, your
signal will be distorted. Turn the MIC level control down until it
does not flash red.
8. Speak or sing into the mic and raise the Meteor Mic’s Headphone
Volume knob until you reach a comfortable listening level.
9. Press the record button and start creating.
Quick Start
To Next Page
Loading...
Need help?
General
