To Next PageTo Next Page
Need help?Do you have a question about the Samson S-com 4 and is the answer not in the manual?
General| Brand | Samson |
|---|---|
| Model | S-com 4 |
| Category | Signal Processors |
| Language | English |
Comprehensive list of safety precautions and warnings for operating the S.com 4 unit.
Detailed explanation of the S.com 4's front panel controls and their functions.
Description of the S.com 4's rear panel connections and I/O options.
Step-by-step instructions for connecting and setting initial controls for the S.com 4.
Guide on how to use the S.com 4's compressor section for gain management.
Instructions on using the S.com 4's Gate function to remove unwanted noise and hiss.
How to configure the S.com 4's Gate section as a Downward Expander to lower signal volume.
Explanation of the S.com 4's Enhancer switch for restoring high-frequency content.
Detailed explanation of the compressor function, its parameters, and applications.
Explanation of the Smart Knee Detector (SKD) feature for automatic knee switching.
How noise gates work to remove unwanted noise and the basic principles of their operation.
The purpose of a Downward Expander in increasing dynamic range and lowering noise floor.
Definition of a Limiter as a compressor type for peak prevention and overload protection.
Description of the Stereo Link mode for stereo operation and channel linking.
How to use the Expander/Gate to effectively reduce unwanted hiss, noise, and crosstalk.
Practical application of noise gates for drums in live sound and recording to control bleed.
Technique for gating sounds with long decays, like piano, using longer release times.
Using compression to balance vocal dynamics for consistent levels during recording.
Applying compression to guitars and bass to even out level variations for better consistency.
Using compression on drums to tighten kick drums and enhance snare/tom clarity.
Using heavy compression to create a 'suspended' vocal effect for better mix presence.
Methods for using compressors to protect speaker systems from overload and peaks.
Diagram and explanation of a live sound system setup using stereo compression.
Diagram and explanation of a live sound system setup using multiband compression.
Overview of interfacing the S.com 4 with various audio applications and signal types.
Explanation of using mixer insert points for processing individual channels or buses.
How to install the S.com 4 in-line between devices like mixers and power amplifiers.
Wiring examples for unbalanced 1/4", XLR balanced, and balanced TRS 1/4" connectors.
Technical data for frequency response, dynamic range, THD, crosstalk, and detector.
Specifications for the Expander/Gate trigger range, attack, and release parameters.
Specifications for the Compressor's threshold, ratio, auto attack/release, and output gain.
Details on the Gate, Release, Enhancer, I/O Meter, Stereo Link, and Operating Level switches.
Specifications for Gain Reduction and Input/Output level meters, and function switch LEDs.
Specifications for audio input/output connectors, impedance, and levels.
Specifications for power supply voltages, consumption, unit dimensions, and weight.
