To Next PageTo Next Page
Need help?Do you have a question about the Samson S-COM PLUS and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Inputs | 2 x XLR, 2 x 1/4" TRS |
| Outputs | 2 x XLR, 2 x 1/4" TRS |
| Phantom Power | No |
| Type | Compressor/Limiter |
| Controls | Threshold, Ratio, Attack, Release, Output |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | >95dB |
| Total Harmonic Distortion | <0.02% |
| Input Impedance | 10k ohms |
| Sidechain I/O | 2 x 1/4" TRS |
| Metering | LED Gain Reduction Meter |
| Dimensions | 19" x 1.75" |
Key safety precautions for operating the S•com plus unit to prevent hazards.
Details of the S.com plus front panel controls and their functions for operation.
Explains the connectors and switches on the rear panel of the S.com plus unit.
Step-by-step guide for initial setup and control normalization of the S.com plus.
Instructions for using the S.com plus compressor for various gain management tasks.
Guide on using the S.com plus gate to remove unwanted noise and enhance desired signals.
How to configure the S.com plus gate section as a downward expander.
Explains how to use the S.com plus Enhancer (EFR) circuit for frequency recovery.
Step-by-step guide to utilizing the S.com plus De-Esser for vocal track sibilance.
Instructions for using the S.com plus Peak Limiter for overload protection.
Explains the SKD (Smart Knee Detector) and its soft-knee/hard-knee operation.
Details the function and application of noise gates for removing unwanted noise.
Describes the purpose and function of the downward expander in increasing dynamic range.
Explains the function of a limiter for preventing peaks and overload.
Describes how to configure the S.com plus for dual-mono or stereo operation.
Explains the side-chain or external key function for processing the compressor's detector circuit.
How to use the Expander/Gate to reduce hiss and noise in audio signals.
Techniques for using noise gates on drums in live sound and recording.
Tips for using noise gates with sounds having a longer decay, like piano.
Method for leveling vocal tracks using compression for consistent levels.
Using compression to even out level differences in guitar and bass recordings.
Applying compression to drums to tighten their sound and improve impact.
Using heavy compression to make a track, like vocals, stand out in the mix.
Using the S.com plus compressor and limiter for speaker system protection.
Diagram illustrating stereo compression setup in a live sound system.
Diagram showing multiband compression using multiple S.com plus units.
Describes using insert points for connecting the S.com plus to single channels or groups.
Explains how to connect the S.com plus in-line between audio devices.
Detailed technical specifications for the S.com plus processor.
Explains the function of various switches on the S.com plus unit.
Details the function and display of meters and LED indicators.
Information regarding mains voltages, power consumption, and inlet.
Dimensions and weight specifications for the S.com plus unit.
