Samson Stage v466 - SR466 Receiver Controls and Features; Receiver Front Panel Controls; Receiver Rear Panel Connections

ENGLISH
ESPAÑOLITALIANO FRANÇAISDEUTSCHE
1. Power Switch -Press to turn the receiver on or o.
2. Power Indicator -Lights red when the receiver is powered on.
3. Volume Controls (Channels 1-4) -Rotate to adjust the individual audio output level from
each channel’s receiver.
4. RF Indicators (Channels 1-4) -Lights green when the corresponding HT6 microphone trans-
mitter is powered on, and there is a wireless signal present and detected by the receiver.
5. Antenna -The antenna mountings allow full rotation for optimum placement. In normal
operation, both antennas should be placed in a vertical position. The antennas can be folded
inward for convenience when transporting the SR466.
SR466 Receiver Controls and Features
5
5
4
2 1
3
7 6 998
6. DC Input -Connect the supplied 12-volt, 500 mA power adapter here.
WARNING: The substitution of any other kind of power adapter can cause severe damage to
the SR466 and will void your warranty.
7. Channels 1 & 2 Outputs -Use these unbalanced ¼” jacks to connect the SR466 Channel 1
and Channel 2 receivers to the line level input of a mixer, amplifier, or other audio equip-
ment. For individual outputs, plug into both jacks, for a mixed signal of both Channel 1 and
Channel 2 receivers, only plug into one of the outputs.
8. Channels 3 & 4 Outputs -Use these unbalanced ¼” jacks to connect the SR466 Channel 3
and Channel 4 receivers to the line level input of a mixer, amplifier, or other audio equip-
ment. For individual outputs, plug into both jacks, for a mixed signal of both Channel 3 and
Channel 4 receivers, only plug into one of the outputs.
9. Mixed Output -This balanced XLR jack is the mixed output of all four receivers to connect
to a line level input of a mixer, amplifier, or other audio equipment. This output can be used
when no additional individual mixing or EQ is necessary per channel.
10. Adaptor Strain Relief -Loop the included adaptor’s cord through the
strain relief to prevent the plug from accidentally detaching from the
receiver.
7
Stage v466: Quad Vocal Wireless System