Samson TROVIS 5573 - Page 7

EB 5573 EN 1-1
Safety instructions and measures
1 Safety instructions and measures
Intended use
TheTROVIS5573HeatingandDistrictHeatingControllerisusedtocontroluptotwocontrol
circuits:
− Control of a primary heat exchanger or boiler with one mixing heating circuit and one
non-mixing heating circuit (both outdoor-temperature-compensated) and control of DHW
heating in the secondary circuit
− Outdoor-temperature-compensated buffer storage tank control with solid fuel boiler and
solar circuit control
− Control of one outdoor-temperature-compensated heating circuit and a DHW heating
with two valves in the primary circuit
− Control of two outdoor-temperature-compensated heating circuits with two valves in the
primary circuit
Theheatingcontrollerisdesignedtooperateunderexactlydenedconditions.Therefore,
operators must ensure that the heating controller is only used in operating conditions that
meetthespecicationsusedattheorderingstage.Incaseoperatorsintendtousetheheating
anddistrictheatingcontrollerinapplicationsorconditionsotherthanthosespecied,contact
SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the
device for its intended purpose or for damage caused by external forces or any other
external factors.
Î Refertothetechnicaldataforlimitsandeldsofapplicationaswellaspossibleuses.
Reasonably foreseeable misuse
The heating controller is not suitable for the following applications:
− Useoutsidethelimitsdenedduringsizingandbythetechnicaldata
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described