Need help?Do you have a question about the Samson VHF Series and is the answer not in the manual?
General| RF Output Power | 10mW |
|---|---|
| Frequency Response | 50Hz-15kHz |
| Operating Frequency | VHF Band |
| Dynamic Range | 100 dB |
| Operating Range | 100 m (328 ft) |
| Microphone Battery | 9V |
| Frequency Range | 174-216 MHz |
| Modulation | FM |
| Battery Type | 9V |
| Microphone Type | Dynamic |
| Polar Pattern | Cardioid |
Details on Volume, Squelch, Power, TX ON, AF Level meter, and A/B LEDs.
Antenna mountings allow rotation for optimum placement; vertical position recommended.
Turns the VR3TD power on and off.
Connects the supplied 12 volt 250 mA power adapter.
Unbalanced 1/4" and Balanced XLR outputs for audio equipment.
Sets balanced output attenuation to line or mic level.
Details on Volume, Squelch, Power, TX ON, AF Level meter, and Power LED.
Allows full rotation for optimum placement; can be folded inward.
Turns the VR3 power on and off.
Connects the supplied 12 volt 250 mA power adapter.
Unbalanced 1/4" and Balanced XLR outputs for audio equipment.
Sets balanced output attenuation to line or mic level.
Input connector for mics and battery door release access.
Details on Battery Level Meter and Audio On/Off Switch.
Power On/Off switch and adjustable Gain control (trimpot).
Battery holder for 9-volt and plastic screwdriver for adjustments.
Details on Audio On/Off, Power On/Off switches, and Battery Level Meter.
Adjustable Gain control (trimpot) and 9-volt battery holder.
Channel matching, placement, power states, battery, and cable connections.
Sequence for powering on the receiver and transmitter.
Adjust transmitter gain and receiver volume for optimal signal on AF meter.
Check level switch, gain structure, or adjust gain/distance to resolve distortion.
Adjust gain, microphone distance, or receiver squelch to improve signal.
Adjust squelch and test transmission signal strength.
Steps to wire the VT3L connector using the provided chart.
Technical details for VT3L, VT3, and VH3 transmitters.
Technical details for VR3TD and VR3 receivers.
To Next Page
