Samsung AC BNNDCH Series - Batch Setting of Installation Options

30
English
Installation Procedure
Installation Procedure
Setting the installation options in a batch
Installation option No. for an indoor unit address: 02XXXX-1XXXXX-2XXXXX-3XXXXX
1 Make sure that the power is supplied
to the indoor unit. If the indoor unit is
not plugged in, it must include a power
supply.
F1
L(L1)
N(L2)
F2
V1
V2
F3
F4
Indoor Unit
2 Set the installation options of indoor units, by referring to the following table and by following
the steps in Common steps for setting the addresses and options on page 23.
• The installation options of indoor units are set to 020010-100001-200000-300000 by default.
• The SEG20 option, Individual control with remote control, allows you to control multiple indoor units
individually by using the remote control.
Option SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
Function Page Mode
Reserved
Use of external room temperature sensor /
Minimizing fan operation when thermostat is off
Central control
Compensation of the
fan RPM
Indication
and details
Indication Details Indication Details Indication
Details Indication Details Indication Details
Use of
external room
temperature
sensor
Minimizing fan operation when
thermostat is off
1)
0 Disuse 0 Disuse
02
0 Disuse Disuse
1 Use Disuse
2 Disuse Use(Heating)
3 Use Use(Heating)
4 Disuse Use(Cooling)
5 Use Use(Cooling)
1Use1
High ceiling
mode
6 Disuse
Use
(Cooling/Heating)
7Use
Use
(Cooling/Heating)
8 Disuse Use (Cooling Ultra low speed)
9 Use Use (Cooling Ultra low speed)
A Disuse
Use (Heating/Cooling Ultra
low speed)
BUse
Use (Heating/Cooling Ultra
low speed)