Samsung AC***KNZDCH/AA - Unit Settings and Options; Option Setting Procedure

33
ENGLISH
Setting an indoor unit address and installation option
f When receiver kit is installed, you can set option codes with the wireless remote control. Use the proper wireless remote control
that can set 24 digit option codes.
The procedure of option setting
High Temp Button
High Fan Button
Mode change
Low Temp Button
Low Fan Button
Entering mode for
setting option
Option setting
mode
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3. Check if you have entered the option setting status.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
CAUTION
Option setting is available from SEG1 to SEG 24
t SEG1, SEG7, SEG13, SEG19 are not set as page option.
t Set the SEG2~SEG6, SEG8~SEG12 as ON status and SEG14~18, SEG20~24 as OFF status.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12 On(SEG1~12) O(SEG13~24
0XXXXX1XXXXX
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2XXXXX3XXXXX
jhjGvktG}Tho|ptuv{jvkllunUGGGZZ YWX]TXWTX_GGG㝘㤸GXXaYXaX`