Disassembly and Reassembly
3-9
No. Parts Procedure
Remark
4
Drain Pump & Hose
2) Remove the 2 screws and separate the Drain
Hose that is on the side lower part of Indoor
Unit (Use +Screw Driver)
5
Fan & Motor
1) Remove the hex nut which is fixed to top of
Fan and separate the Fan from the Motor.
(Use Monkey Spanner)
2) Remove the 3 hex nuts which is fixed to Motor
and separate the Motor from the Indoor Unit.
(Use Monkey Spanner)
6
Temperature Sensor
1) Remove the 6 screws which is fixed to
Evaporator and separate the Partition.
2) Separates the Temperature Sensor which is
fixed to Evaporator Pipe with the fixing clip
together by the hand.
To Next Page
Loading...
