Samsung AC071MN4PKH - 4 Troubleshooting; Setting an Indoor Unit Address and Installation Option

4-1
▶ Indoor address set-up and installation options, set the remote control option..
ADDRESS setting and indoor settings option haohni setting is not possible at the same time, set each of the options.
If necessary, set up the indoor address setting installation options, you must enter twice.
4-1-1. The procedure of setting option
▶ MR-EC00 and MR-EH00 remote controls
CAUTION
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0XXXXX1XXXXX
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2XXXXX3XXXXX
On (SEG1~12) Off (SEG13~24)
High Temp button
High Fan button
Mode button
Low Temp button
Low Fan button
Entering the
mode for setting
the options
Setting the
option values
t5IFUPUBMOVNCFSPGBWBJMBCMFPQUJPOTBSF4&(UP4&(
t#FDBVTF4&(4&(4&(BOE4&(BSFUIFQBHFPQUJPOTVTFECZUIFQSFWJPVTSFNPUFDPOUSPMNPEFMTUIFNPEFTUP
set values for these options are skipped automatically.
t4FUBEJHJUWBMVFGPSFBDIPQUJPOQBJSJOUIFGPMMPXJOHPSEFS4&(BOE4&(ĺ SEG4 and SEG5
ĺ SEG6 and SEG8 ĺ SEG9 and SEG10 ĺ SEG11 andSEG12 ĺ SEG14 and SEG15 ĺ SEG16 and SEG17 ĺSEG18 and
SEG20 ĺ SEG21 and SEG22 ĺ SEG23 and SEG24
4. Troubleshooting
4-1 Setting an indoor unit address and installation option
1.Enter the mode for setting the options :
a. R1emove the batteries from the remote control,and then insert them again.
b. While holding down the (High Temp) and (Low Temp) buttons simultaneously, insert thebatteries into the remote control.
c. Make sure that you are entered to the mode forsetting the options:batteries into the remote control.
2. Set the option values.
Step 1
Enter the mode for setting the options